To recharge the battery with the Circuit Control. Raise a sound or voice alert about low battery charge with the Alarm Button, or to turn some equipment on or off, or to start a genset For example, you can configure the Battery Monitor to automatically The Battery Monitor can be configured to manage channels of an NMEA 2000 digital switching system, and/or trigger a digital alarm unit compatible with standard Device connection (Device's wire colours are in BOLD) Installation description strings a PC gateway and software (like CAN Log Viewer or ActiSense NMEA Reader) may be required for this method. The Device can be also configured over NMEA 2000 using You can specify battery parameters such as nominal capacity and voltage, chemistry, etc. The Device incorporates a MicroSD card slot which allows using a standard FAT-formatted card to configure it and update its firmware.Īt minimum, you should specify drop voltage and maximum current for the connected shunt. Battery Monitor YDBM-01N (shunt, T-connector and MicroSD card are not supplied) State and health more accurately and report temperature along with voltage and current data. It can be configured to use data from a NMEA 2000 thermometer connected to the battery to detect the charge To operate as intended, it requires an appropriate external shunt (not supplied with the Device) shunts in the rangeįrom 5A to 1200A are widely available (please refer to Section V "Choosing a Shunt" of the User Manual). alternator, wind generator, etc.) or load (windlass, refrigerator, etc.), but it is primarilyĭesigned for monitoring a marine battery. The Battery Monitor can be used with any single DC source (i.e. nominal capacity and chemistry) to NMEA 2000 and can turn on the genset or warn when the battery state is critical. The device reports measured voltage and current, calculated health and charge state, and
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |